An Analytic Study of the Effect of the Movable Shading Devices Attached to Semi-Open Spaces on the Annual Energy Consumption A Case Study of Residential Buildings in Tehran

Document Type : Original Article

Authors

1 Assistant Professor, Faculty of Architecture and Urban Planning, University of Art, Tehran, Iran

2 Master in Architecture and Energy, Faculty of Architecture and Urban Planning, University of Art, Tehran, Iran

Abstract

One of the most important components of a building that influences physical properties, environmental behavior and responses, and energy consumption is the building envelope. Therefore, accurate decision-making in this regard will be of particular importance. Most of the measures taken to reduce energy consumption in buildings are somehow active and mechanical strategies that not only impose the increase of construction cost on employers but also the emission of greenhouse gases in the global environment. Regarding the importance of the role of architects, if the initial decisions in the design process are made based on environmental issues and climatic approach, a considerable saving on cost and energy consumption can be achieved. In the meanwhile, passive systems are the most efficient and clean ways to meet the thermal needs of a building by means of utilizing renewable energy resources such as solar energy, wind power, and so on. In this type of system, fossil fuels and mechanical powers are rarely used. Among the mentioned methods, the element of shading device is one of the most effective solutions that has been widely used in traditional Iranian architecture. This solution has a high potential to be implemented in contemporary architecture as well. Measurements and simulation studies have shown that balcony form and solar protection can significantly affect the thermal comfort of occupants on the balcony as well as in the adjacent room. In this research, one of the existing buildings equipped with a glass-covered balcony was selected as a case study and experimental measurements were taken by two data loggers located in the balcony and adjoining room in order to record the temperature fluctuation. The simulation process was validated by comparing the experimental results. The base case building was modeled in Openstudio software (2.6.0) and Energyplus 8.9 and was then utilized for annual energy simulation. The depth of semi-open space, the window area of the adjoining wall, and its thermal conductivity coefficient in the two types of balconies and porches were considered as the variables. The effect of shading strategies such as movable louver and glass cover on thermal performance was comparatively investigated. The simulation results indicated that the use of an open-angle louver as well as a movable glass partition in summer and winter respectively would enhance the thermal performance of the room adjacent to semi-open space. Regarding under-construction buildings, the effect of using attached shading devices on thermal performance on cold days of a year increases based on the depth of the semi-open space along with window to wall ratio. Although the reduction of the thermal conductivity coefficient of window would make the attached glass partition more effective in the winter, the negative effect has to be considered in the summer. Based on the research findings, this paper concluded in determining a design guideline for the application of a movable attached shading device of semi-open spaces in residential buildings in Tehran metropolitan city.

Keywords


-  دفتر مقررات ملی ساختمان ایران (1389). مقررات ملی ساختمان ایران، مبحث نوزدهم «صرفهجویی در مصرف انرژی». تهران: نشر توسعه ایران.
-  دفتر مقررات ملی ساختمان ایران (1392). مقررات ملی ساختمان ایران، مبحث چهارم «الزامات عمومی ساختمان». تهران: نشر توسعه ایران.
-  فیاض، ریما (1392). سطح بهینه پنجره ساختمانهای مسکونی در اردبیل و تهران. نامه معماری و شهرسازی، ۱۰، ۱19-105.
-  وبگاه اداره کل هواشناسی استان چهارمحال و بختیاری:  www.chaharmahalmet.ir
 
-   Ayokunle, O. T. (2015). The effect of balcony on thermal performance of high rise office building in tropical climate.Master Thesis in Architecture, Universiti Teknologi Malaysia.
-   Aelenei, D., Azevedo Leal, H., & Aelenei, L. (2014). The use of attached-sunspaces in retrofitting design: the case of residential buildings in Portugal. Energy Procedia, 48, 1436 – 1441.
-   Antoniou, A., & Yannas, S. (2017). The residential balcony in the Mediterranean climates. PLEA.ASHRAE GUIDLINE 14-2002P.15. 
-   Craven, C., & Garber-Slaght, R. (2011). Evaluating Window Insulation: Curtains, Blinds, Shutters, and More.Fairbanks: Cold Climate Housing Research Center.
-   Clarke, J., Johnstone, C., Kim, J., & Strachan, P. (2008). Study of the Energy Performance of Korean Apartment Buildings with Alternative Balcony Configurations, World Renewable Energy Congress (WRECX).
-   EnergyPlus Engineering. (2015). The US Department of Energy. Retrieved 23 May, 2015 from http://apps1.eere.energy.gov/buildings/energyplus/energyplus_documentation.cfm.  
-   Dzieszko, K., & Warchal, M. (2015). Influence of the balcony glazing construction on thermal comfort of apartments in retrofitted large panel buildings. Procedia Engineering, 108, 481 – 487.
-   Hilliaho, K. (2017). Energy Saving Potential and Interior Temperatures of Glazed Spaces: Evaluation through Measurements and Simulations. Doctoral Dissertation in Science and Technology, Tampere University of Technology.
-   Hilliaho, S., Köliö, A., Pakkala, T., Lahdenivu, J., & Vinha, J. (2016). Effects of added glazing on Balcony indoor temperatures: Fieldmeasurement. Energy and Buildings, 128, 458–472. 
-   Hilliaho, k., Kovalainen, V., Huuhka, S., & Lahdensivu, J. (2016). Glazed spaces: A simplified calculation method for the evaluation ofenergy savings and interior temperatures, Energy and Buildings, 125, 27–44.
-   Yannas, S., & Tsichritzis, L. (2015). The glazing of balconies as a retrofitting solution for reducing the heating load of the adjacent room in Athens. PLEA Conference-Architecture in (R)Evolution, Bologna, Italy.